I am designing Inverter for motor control by using the microcontroller F28069M. If I do programming using this and use EPWM module then how i will give gate pulses to the inverter gate driver. I know ...

we have a microelectronic system which draws power from the REG1 configured to supply 3.3V when the battery pack is connected. However, when the battery pack is not connected, we will supply 3.3V from ...

Other Parts Discussed in Thread: BQ25750, I am using the BQ25750EVM and will be using the BQ25750 chip in a final design. We want to use resistors to fix the number of cells in the battery as well as ...

We are developing a board with a 100Base-T1 interface using the DP83TC812R-Q1 chip. We were checking this with our carrier board, like the below connection. We have isolated the DP83867ERGZR chip ...

I am planning to use OPA1664 as a pre-amplifier to amplify microphone signal, using low pass sallen key topology which I have generated from TI webench. I am using dual power supply (+/- 1.5V).

i have a dbx driverack pa and i want to change my op amp for better op amp. inside i have four 4580 jrc and i want change by Lme49720. do you think it compatible or do you have a better choice for ...

I have designed my own board based on AM2634 MCU and try to connect and load the program via XDS110. I get the following error: "ASSERT: 0.1s: soc/am263x/soc_rcm.c ...

I have tried the simulation file of UCC28730 available from TI website using Pspice V16 . After 1.09msec, the pulse from DRV pin stops. So that the output is not reaching the expected value. We tried ...