2006年11月14日 · One place that comes to mind is the braces where they meet the inner rocker. I can use a cat's paw or small crow bar to hold it using the frame for leverage but have you ever tried holding 5 things and a welding shield while trying to weld something? I "reverse clamp" thingy would work really well there.

2023年12月29日 · tool Not exclusive to dealers Also good rear gear sets are marked with pinion height No`s compare this to original fitted and calculate pinion height Remember salisbury carrier bearing preload is more often 80% time set up incorrectly due to poor knowledge and insufficient correct tooling or correct shims .

4 天之前 · Proper pot metal restoration is labour-intensive and expensive. Traditionally. Then there's this: Pot Metal - Muggy Weld It's a link to a page that extols a low melting point flux & solder that they sell, with a series of video "how to" links.

2023年10月6日 · But I was still curious about the use of this Kent Moore tool. I've also seen different specs written about the best amount of travel being from .070" up to .150" so there seems to be lots of conflicting info on that.

2024年12月10日 · Also, some marine motors are reverse rotation GM Marine Small Block Compatible 350 c.i. Engine - 350 Horsepower - Base Dressed - Carbureted BluePrint Engines 355 c.i. small block GM style marine crate engine - dressed longblock with carburetor.

2022年2月20日 · A set of small-tip needle-nose pliers opened up might fit in the holes and give enough leverage to turn it out.

2022年11月26日 · Try to first remove the old 1968-72 Chevelle secondary steering shaft by loosening the upper collar clamp of the steering shaft located at the firewall end. Next completely remove the lower Chevelle steering Rag Joint by loosening the 12 point bolt at the removable steel Female 13/16” - 36 Splined BBC Coupler Plate which is connected to the ...

2024年9月11日 · 1970 LS6, unrestored, 4 speed,special ordered orange 1972 Nova, 557ci, Legend 5 speed, FiTech EFI 8, lemons Headers, 723hp/690tq

2024年11月24日 · X-2 just do it, invest in a sync-tool for the carbs, I got mine from Dorvak Racing. I ran a low-rise Offy ...

2013年8月31日 · Heres a few pics with the clamp and spring on number 7 header tube on 68198 hedman elites. I shortened the spring a bit. Spring is lined up with adjusting rod and rubs on nothing. And no signs of clamp trying to twist as it is tight on the header tube. Will it come loose, don't know yet. But I will keep an eye on it.